10mm Solderless 2-Wire Connector Clip
Each of our LED Strip Lights comes with a lead wire on each end, therefore, the 16 ft strip light can be cut into 2 pieces, and be used/connected as if it were two separate fixtures. Now, if you wish to use 3 separate pieces out of 1 strip light, then you will need to buy this connector, to attach to the end of the third piece and have it be the lead wire.
Make sure to seal the end with a silicon sealant after each cut.
Important Note:
By adding this connector you compromise the fixture and is only recommended for professional lighting contractors. Therefore the fixture is not covered by our warranty in case you need to use this connector.
